NSTRUCTIONS FOR self-weeding laser transfer paper 1, Pre-printing a, The selection of laser printer. Should use the laser color printer with white toner like OKI C711WT, because the difference attributes for Toner , thisdark no cut transfer paper can not apply any other laser printer. b, Self-weeding heat transfer paper have A(Blue Back Label) and B(Gray Back Label). c, B(Gray Back Label) has a layer of white film on the surface, and the size is smaller than A(Blue Back Label), so that we can peel B off A smoothly. d, We should choose "Heavy"in print attribution. e, Please adjust the temperature to 160℃-170℃and the time to 60s-70s, finally depending on your own press machines.2, Transfer Steps a, Print the picture on the front side of A. b, Put B front onto A front, then overlap. b, Adjust the temperature to 160℃-170℃and the time to 60s-70s. When time's up, peel B off A rapidly without leaving the flat (Hot Tear). If there has remaining glue on the edge of A, you need to cut off. f, Reset the temperature to 160℃-170℃and the time to 10s-15s, then put the T-shirt onto the flat and put A(Printing Side) onto the T-shirt. When time's up, after several seconds, peel A off the T-shirt.(Warm Tear)  1.if you need transfer small image ,need cut a and b ,ensure b paper is small than a paper2.Peel b from a immediately (1-3s) 3.After transfer ,take off t-shirt from press machine and after 10-15s ,peel a paper form t-shirt ,and you can try peel from four corners get the best way to peel off 4.Then you can put the t-shirt on the press and put oil paper on t-shirt ,press 3-5s , strengthen the fastness. 5.24 hours after the completion of the transfer you can wash the t-shirt